Abstract:
Chitosan has amine and amino groups which have the ability to generate cationic type surfactants when
combine with H+ ions. Thus its action as a cationic emulsifier is suitable for negatively charged siliceous
aggregates used for road paving in Sri Lanka. This study consisted of two parts. Firstly, water soluble
Chitosan was tested for suitability of using as an emulsifier in the production of cationic bituminous
emulsions and secondly Chitosan was used as an additive to mix with bitumen emulsion. In the first part,
currently using amine emulsifier was replaced at 20% intervals and tested for emulsion properties;
emulsion viscosity, storage stability, settlement test, sieve test and breaking of emulsion. In the second
part, Chitosan was added to emulsion and viscosity, storage stability and break time were tested. Results
of first part indicated that Chitosan replacement was only possible up to 10% replacement for cationic
slow setting type of emulsions but rheological properties of rapid setting emulsions could be improved by
replacing up to 60% of amine emulsifier with Chitosan. A significant increase in viscosity from 16 SSU
(with 0% Chitosan) to 43 SSU (with 60% Chitosan) was observed for rapid setting emulsions. Storage
Stability showed the optimum value of zero at 40% replacement and all the values up to 60% replacement
were found to be within the ASTM specified level of ±1%. Break time measurements suggested that for
slow setting type emulsions Chitosan use as an emulsifier has increased the emulsion breaking rate.
Further high viscous and stable rapid setting emulsion could be obtained without hindering the
compliance to ASTM standard by replacing the amine emulsifier with Chitosan. Results of second part
suggested that Chitosan acts as a viscosity modifier and increases the emulsion viscosity from 26SSU to
92SSU when added at 0.2% of emulsion weight. But this addition has increased the settling tendency of
emulsion thus most suited to be mixed at the point of use. In both cases, at a critical amount of added
Chitosan was observed. This maximum limit was found to be 0.2% (w/w).
