Abstract:
A blast load acting on a structure can be considered as an amalgamation of overpressure and
impulse over an extremely short duration, which can cause catastrophic exterior and internal
damage. Such blast loads can be generated due to either intentional or accidental actions. Due
to growing threats, over the years, researchers have given special attention to studying the
behaviour of structures when subjected to blast loads, and numerical modelling is a common
approach used for such studies due to its practicality. However, existing modelling methods
using advanced Finite Element Modelling (FEM) software can be complicated and
computationally expensive and, in most cases, aims at studying the localised behaviour due to
blast loads. On the other hand, Advanced FEM tools may require specialised expertise, limiting
their accessibility for day-to-day structural design activities. This study aims to develop a
general yet accurate model to simulate the complex behaviour of blast loads on a multi-storey
building. To achieve this aim, two objectives are defined as identifying the applicable blast
load parameters to represent the blast event accurately and simulating the behaviour of a
building under positive overpressure due to blast loads. The approach approximates the blast
load as a force at each node in the front face by multiplying the pressure by the tributary area
and is implemented using finite element analysis. The approach is validated against data from
open literature shown to be effective in predicting the response of structures to blast loads at a
conservative level (49% difference for near-field explosions while 23% difference for far-field
explosions). In this study, reinforced concrete buildings with three, six, and twelve storeys were
modelled with blast loads of 1000 kg TNT at standoff distances of 5 m, 10 m, and 30 m from
the building. Here, when the standoff distance is 5 m, it represents a near-field explosion,
whereas when the standoff distance is 30 m, it represents a far-field explosion. The top-storey
displacement due to the blast load was obtained as the main result, and a comparison was made
to analyse the effect of blast load when there are shear walls and see the effect of slabs in
resisting blast loads. The analysis was carried out using the commercially available finite
element package, Midas Gen. The results demonstrate the potential of the proposed modelling
technique to model the effects of the blast event with reasonable accuracy. However, it must
be noted that the scope of this proposed approach is limited to structures that only need an
initial blast load analysis and are not categorised as being vulnerable to blast loads. The results
indicated that this method is more accurate for far-field explosions than for near-field
explosions, where the expected behaviour of the structure is global and local, respectively. The
top floor displacement is less than the no-shear wall scenario when there are shear walls. Also,
the top floor displacement is less when there are slabs than in the no-slab scenario. In both
situations, the rigidity of the structure due to laterally applied blast loads is high with shear
walls and slabs. When the standoff distance is higher from the structure, it results in a uniform
blast load on the front face, and at the same time, when the height of the buildings increases,
they behave as cantilevers, and hence the top floor displacement is high. When the standoff
distance is lesser from the structure, the blast load is localised, and the variation of top floor
displacement is opposite to that in the far-field explosion.