Abstract:
The construction industry faces a significant challenge in the form of high costs associated with construction materials. As a means of addressing this challenge, the industry has explored various alternatives to reduce costs. One such effort includes the use of alternative or waste materials in construction. The adoption of waste materials in the construction industry offers a viable solution to natural resource depletion while providing an opportunity for proper solid waste management.
The construction industry relies heavily on the use of bricks and blocks, which require significant quantities of natural resources. As a result, considerable research has focused on the introduction of waste materials into the bricks and blocks manufacturing process, such as Glass Waste, waste tea, rice husk ash, crumb rubber, and cement kiln dust, as a substitute for sand. Among these materials, glass waste plays a particularly prominent role in increasing municipal solid waste.
According to current literature, the compressive strength of masonry units is dependent on the percentage of glass waste used, with peak strength observed at 20%-25% replacement. Beyond this threshold, subsidence becomes noticeable. The maximum replacement percentage that can be used without significantly reducing the compressive strength of general masonry units is 50%. However, it is essential to evaluate masonry strengths, rather than just masonry unit strengths, when designing walls within the framework of construction quality. This research aims to evaluate the compressive and flexural strength of wall panels cast from masonry units in which 50% of the fine aggregate has been replaced with glass waste. The study will compare the results obtained with that of the strength requirement specified in the BS EN 1996-1-1.
The compressive strength of GWAB is observed to be higher than that of CSB, as reported in the literature. However, experimental values indicate a significant reduction in compressive strength as compared to the values calculated from BS EN 1996-1-1. In light of this, 𝐾𝐺𝑊𝐴𝐵=0.48 factor has been defined for the design of wall panels according to equation 3.1 in BS EN 1996-1-1 using general-purpose mortar and GWAB. Furthermore, the equation 3.1 in BS EN 1996-1-1 can be redefined as follows with the 𝐾𝐺𝑊𝐴𝐵 factor. 𝑓𝑘=𝐾𝐺𝑊𝐴𝐵𝐾𝑓𝑏𝛼𝑓𝑚𝛽, definitions of other parameters in the equation defined in BS EN 1996-1-1. This factor is crucial for ensuring optimal performance and durability of the wall panels.
The characteristic flexural strength of GWAB wall panels perpendicular to the bed joint and parallel to the bed joint was compared with the theoretical and experimental values of CSB wall panels and graphically represented in the charts.
